NEPTUNE STARTER WORKFLOW

START CONSERVATIVE. VERIFY EVERY STEP.

Use the exact model profile supplied by the printer or slicer vendor, then verify mechanics, Z offset, temperature, flow and motion before increasing speed.

OPEN PRINTER SETTINGS →NEPTUNE GUIDES →

NEP
TUNE

Baseline sequence

Confirm exact Neptune model, nozzle and firmware profile.
Inspect belts, wheels or rails, gantry and toolhead fasteners.
Clean the plate, run mesh and set Z offset.
Use a conservative material profile and small test.
Tune temperature and flow before retraction or speed.

Do not copy blind speed claims

Maximum advertised motion is not the same as reliable print speed. Volumetric flow, cooling, acceleration, model geometry and material determine the usable limit.

Save a known-good profile before experimenting. Members can preserve printer, material and repair histories in Profile Vault.