Private on-device repair evidence

Over-Extrusion, Blobs, and Zits

Fix swollen walls, rough top surfaces, seam blobs, and excess plastic without starving the print.

Not started0 of 7 stepsNot yet saved

First safe actionRun the first safe check and change one variable at a time.

Proof targetA small representative test no longer shows the original symptom.

Controlled tests logged0

Verification resultNot recorded

Machine and material context

Record the setup that produced this result

Printer Extruder Material Slicer Nozzle / layer

Saved only in this browser with the repair. Nothing is uploaded.

Optional visual proof

Before repairChoose a photo After proof testChoose a photo

Photos stay in this open page only and are never stored or uploaded. They appear in the printed report while the page remains open.

One variable at a time

No controlled tests have been logged yet. Return to Workshop Mode and record each change before running another test.

Repair sequence

1
Confirm physical nozzle size and slicer nozzle profile.Not completed
2
Verify filament diameter setting and remove any accidental global flow override.Not completed
3
Inspect for hotend leakage or nozzle buildup.Not completed
4
Print a controlled flow calibration and adjust in small increments.Not completed
5
Tune temperature for the material.Not completed
6
Tune pressure advance/linear advance if the printer supports it.Not completed
7
Adjust seam placement/wipe only after flow is correct.Not completed

Private workshop notes

No notes recorded.

Model: 100 mm extrusion and thin-wall test
Setup: Use the same nozzle, material and hotend temperature planned for the print.
Pass: Flow is smooth and the wall is continuous with stable width.
If unchanged: Clicking, gaps, pulsing or inconsistent line width remains.

Matched next step

Pair practical Hub guidance with Caffeine Monster and the clear three-product Character Collectibles Starter Pack.