Private on-device repair evidence

Purge Tower Falling Over or Failing

Improve the tower’s first layer, width, cooling, speed, and placement, then reduce unnecessary tool changes or use a safer purge strategy.

Not started0 of 8 stepsNot yet saved

First safe actionRun the first safe check and change one variable at a time.

Proof targetA small representative test no longer shows the original symptom.

Controlled tests logged0

Verification resultNot recorded

Machine and material context

Record the setup that produced this result

Printer Extruder Material Slicer Nozzle / layer

Saved only in this browser with the repair. Nothing is uploaded.

Optional visual proof

Before repairChoose a photo After proof testChoose a photo

Photos stay in this open page only and are never stored or uploaded. They appear in the printed report while the page remains open.

One variable at a time

No controlled tests have been logged yet. Return to Workshop Mode and record each change before running another test.

Repair sequence

1
Clean the plate and verify the tower’s first layer.Not completed
2
Move the tower to a reliable bed area if the slicer allows it.Not completed
3
Increase tower width, brim, wall count, or density moderately.Not completed
4
Reduce purge speed and improve cooling for the tower material.Not completed
5
Tune temperature and wipe to reduce blobs.Not completed
6
Check the model and tower do not cross during travel.Not completed
7
Reduce unnecessary colour changes through model or slicer planning.Not completed
8
Run a shorter multicolour test with the same tower height and transitions.Not completed

Private workshop notes

No notes recorded.

Model: Small representative test print
Setup: Use the same printer, material, slicer and key settings as the failed model.
Pass: The original symptom is absent and the target feature is repeatable.
If unchanged: The symptom remains in the same location or stage.

Matched next step

Pair practical Hub guidance with Caffeine Monster and the clear three-product Character Collectibles Starter Pack.