Skip to main content
HUB.STLBEAST3D printing knowledge hubFix · learn · print
⌂
← Repair BenchWorkshop ModeFull guide
Private on-device repair evidence

Resin Lift Speed and Distance Tuning

A detailed STLBEAST repair guide to reduce peel failures without making prints unnecessarily slow. Learn how to recognize the symptom, rank the likely causes, apply safe fixes in order, verify the result, and prevent the failure from returning.

Not started0 of 8 stepsNot yet saved
Visual repair reference for resin lift speed and distance tuning
A small representative test no longer shows the original symptom.
First safe actionRun the first safe check and change one variable at a time.
Proof targetA small representative test no longer shows the original symptom.
Controlled tests logged0
Verification resultNot recorded
Machine and material context

Record the setup that produced this result

Saved only in this browser with the repair. Nothing is uploaded.

Optional visual proof

Add before and after photos for this report

Photos stay in this open page only and are never stored or uploaded. They appear in the printed report while the page remains open.

One variable at a time

Controlled test history

No controlled tests have been logged yet. Return to Workshop Mode and record each change before running another test.
Repair sequence

Step completion

  1. 1
    Document the failure and confirm that it matches this guide: Layers detach, supports bend, or the film snaps loudly during lift.Not completed
  2. 2
    Return extreme overrides to a known printer, nozzle, material, and slicer profile so the diagnosis starts from a stable baseline.Not completed
  3. 3
    Check lift speed too high. Listen for peel behavior.Not completed
  4. 4
    Check lift distance too short. Use printer/resin baseline.Not completed
  5. 5
    Inspect retract speed too high. Adjust speed before distance.Not completed
  6. 6
    Rule out large cross-section. Verify on representative geometry.Not completed
  7. 7
    Change only the single setting or hardware condition supported by the evidence, then run a small test that reproduces the original failure.Not completed
  8. 8
    Compare the test against the target condition, record the successful value, and save it in a printer/material profile before repeating the full print.Not completed
Private workshop notes

Observations and winning values

No notes recorded.

Verification test

Model
Small resin validation print
Setup
Use the final resin, temperature, exposure, lift and support profile.
Pass
The part completes with clean details, attached supports and no layer split.
If unchanged
The part detaches, splits, warps or loses detail.
Use the evidence, not guesswork

Keep the winning setup and change only one variable in the next test.

Return to Workshop Mode →
Caffeine Monster
Matched next step

Keep the useful workflow going.

Pair practical Hub guidance with Caffeine Monster and the clear three-product Character Collectibles Starter Pack.

View matched productSee Character Collectibles Starter PackGet useful updatesUnlock complete tools
STLBEAST ecosystemSolve the print on Hub. Discover the next project in the Store.