Private on-device repair evidence

Resin Print Not Sticking to the Build Plate

A detailed STLBEAST repair guide to restore bottom-layer adhesion without excessive exposure. Learn how to recognize the symptom, rank the likely causes, apply safe fixes in order, verify the result, and prevent the failure from returning.

Not started0 of 8 stepsNot yet saved

Visual repair reference for resin print not sticking to the build plate — A small validation print remains attached and completes cleanly.

First safe actionConfirm plate leveling, resin temperature and release conditions first.

Proof targetA small validation print remains attached and completes cleanly.

Controlled tests logged0

Verification resultNot recorded

Machine and material context

Record the setup that produced this result

Printer Extruder Material Slicer Nozzle / layer

Saved only in this browser with the repair. Nothing is uploaded.

Optional visual proof

Add before and after photos for this report

Before repairChoose a photo After proof testChoose a photo

Photos stay in this open page only and are never stored or uploaded. They appear in the printed report while the page remains open.

One variable at a time

Controlled test history

No controlled tests have been logged yet. Return to Workshop Mode and record each change before running another test.

Repair sequence

Step completion

1
Document the failure and confirm that it matches this guide: The raft remains in the vat or only part of the model attaches to the plate.Not completed
2
Return extreme overrides to a known printer, nozzle, material, and slicer profile so the diagnosis starts from a stable baseline.Not completed
3
Check build plate not leveled. Re-level the plate.Not completed
4
Check bottom exposure too low. Clean it as specified.Not completed
5
Inspect plate contamination. Use resin-tested bottom exposure.Not completed
6
Rule out lift force too high. Reduce lift stress.Not completed
7
Change only the single setting or hardware condition supported by the evidence, then run a small test that reproduces the original failure.Not completed
8
Compare the test against the target condition, record the successful value, and save it in a printer/material profile before repeating the full print.Not completed

Private workshop notes

Observations and winning values

No notes recorded.

Verification test

Model: Small resin validation print
Setup: Use the final resin, temperature, exposure, lift and support profile.
Pass: The part completes with clean details, attached supports and no layer split.
If unchanged: The part detaches, splits, warps or loses detail.

Matched next step

Keep the useful workflow going.

Pair practical Hub guidance with Caffeine Monster and the clear three-product Character Collectibles Starter Pack.

View matched product See Character Collectibles Starter Pack Get useful updates Unlock complete tools

Resin Print Not Sticking to the Build Plate

Verification test

Keep the winning setup and change only one variable in the next test.

Keep the useful workflow going.