Private on-device repair evidence

Support Z Distance Tuning

A detailed STLBEAST repair guide to set a predictable separation gap based on layer height and material. Learn how to recognize the symptom, rank the likely causes, apply safe fixes in order, verify the result, and prevent the failure from returning.

Not started0 of 8 stepsNot yet saved

Visual repair reference for support z distance tuning — A small representative test no longer shows the original symptom.

First safe actionRun the first safe check and change one variable at a time.

Proof targetA small representative test no longer shows the original symptom.

Controlled tests logged0

Verification resultNot recorded

Machine and material context

Record the setup that produced this result

Printer Extruder Material Slicer Nozzle / layer

Saved only in this browser with the repair. Nothing is uploaded.

Optional visual proof

Add before and after photos for this report

Before repairChoose a photo After proof testChoose a photo

Photos stay in this open page only and are never stored or uploaded. They appear in the printed report while the page remains open.

One variable at a time

Controlled test history

No controlled tests have been logged yet. Return to Workshop Mode and record each change before running another test.

Repair sequence

Step completion

1
Document the failure and confirm that it matches this guide: Supports either weld to the part or leave a sagging rough underside.Not completed
2
Return extreme overrides to a known printer, nozzle, material, and slicer profile so the diagnosis starts from a stable baseline.Not completed
3
Check gap too small. Express the gap in layer increments.Not completed
4
Check gap too large. Test one small underside.Not completed
5
Inspect gap not aligned to layer height. Tune cooling.Not completed
6
Rule out material remains too soft. Use interface layers.Not completed
7
Change only the single setting or hardware condition supported by the evidence, then run a small test that reproduces the original failure.Not completed
8
Compare the test against the target condition, record the successful value, and save it in a printer/material profile before repeating the full print.Not completed

Private workshop notes

Observations and winning values

No notes recorded.

Verification test

Model: Small overhang and support coupon
Setup: Use the final layer height, support interface and cooling profile.
Pass: Supports detach predictably and the underside is intact.
If unchanged: Supports fuse, collapse or leave severe scars.

Matched next step

Keep the useful workflow going.

Pair practical Hub guidance with Caffeine Monster and the clear three-product Character Collectibles Starter Pack.

View matched product See Character Collectibles Starter Pack Get useful updates Unlock complete tools

Support Z Distance Tuning

Verification test

Keep the winning setup and change only one variable in the next test.

Keep the useful workflow going.