PUBLIC SETTINGS SAMPLE
START WITH A RANGE. TUNE WITH EVIDENCE.
These values are conservative starting ranges. Always begin with the printer and material manufacturer profile, then use small calibration tests.
SLICE
TEST
TEST
Recommended starting range
PLA · Direct drive / unknown · balanced
Nozzle temperature200–215°C
Bed temperature55–65°C
Print speed45–70 mm/s — Start near the middle of the range.
Retraction0.8–1.4 mm @ 30–45 mm/s
Cooling80–100% after layer 3
ContextStrong starting material for most decorative prints. Nozzle selected: 0.4 mm.
STARTER RANGE, NOT A MAGIC PROFILE
Use the range to begin testing—not to override your printer maker.
Start from a manufacturer profile
Printer, hotend, nozzle, filament and build plate limits come first. Use this tool when you need a conservative comparison point, not as permission to exceed hardware limits.
Calibrate dependencies first
Stable mechanics, first layer and dry filament make temperature, flow and retraction tests meaningful. A slicer profile cannot compensate reliably for changing hardware.
Save the profile that actually worked
Once a controlled test succeeds, preserve the printer, material, nozzle and slicer context so the result can be repeated instead of rediscovered.