Private on-device repair evidence

3D Print Not Sticking to the Bed

Fix poor bed adhesion, lifting first layers, loose corners, and prints that detach from the build plate.

Not started0 of 7 stepsNot yet saved

First safe actionClean and correctly seat the build plate before changing Z offset.

Proof targetA one-layer test joins evenly in the centre and corners.

Controlled tests logged0

Verification resultNot recorded

Machine and material context

Record the setup that produced this result

Printer Extruder Material Slicer Nozzle / layer

Saved only in this browser with the repair. Nothing is uploaded.

Optional visual proof

Before repairChoose a photo After proof testChoose a photo

Photos stay in this open page only and are never stored or uploaded. They appear in the printed report while the page remains open.

One variable at a time

No controlled tests have been logged yet. Return to Workshop Mode and record each change before running another test.

Repair sequence

1
Wash or clean the plate using the surface manufacturer’s approved method; avoid touching the print area afterward.Not completed
2
Run bed mesh or leveling, then print a single-layer test across several bed locations.Not completed
3
Adjust Z offset in very small increments until adjacent lines touch without ridges or transparent scraping.Not completed
4
Confirm the slicer selected the correct build surface and material profile.Not completed
5
Use a slower first layer and the filament maker’s temperature range.Not completed
6
Reduce early fan or shield the printer from drafts when the material requires it.Not completed
7
Add a brim only after the mechanical and surface checks are correct.Not completed

Private workshop notes

No notes recorded.

Model: Single-layer five-zone test
Setup: Use the final plate, material, mesh and first-layer profile.
Pass: Lines join evenly in the centre and corners, with no scraping, gaps or lifting.
If unchanged: One or more zones remain loose, transparent, ridged or detached.

Matched next step

Pair practical Hub guidance with Caffeine Monster and the clear three-product Character Collectibles Starter Pack.