Private on-device repair evidence

Nozzle Too Close to the Bed

Identify an over-squished first layer, scraping nozzle, blocked extrusion, ridges, and elephant-foot symptoms.

Not started0 of 6 stepsNot yet saved

First safe actionRun the first safe check and change one variable at a time.

Proof targetA small representative test no longer shows the original symptom.

Controlled tests logged0

Verification resultNot recorded

Machine and material context

Record the setup that produced this result

Printer Extruder Material Slicer Nozzle / layer

Saved only in this browser with the repair. Nothing is uploaded.

Optional visual proof

Before repairChoose a photo After proof testChoose a photo

Photos stay in this open page only and are never stored or uploaded. They appear in the printed report while the page remains open.

One variable at a time

No controlled tests have been logged yet. Return to Workshop Mode and record each change before running another test.

Repair sequence

1
Stop the print if the nozzle is scraping the surface.Not completed
2
Inspect the nozzle and plate for damage or debris.Not completed
3
Raise Z offset in very small increments while running a first-layer pattern.Not completed
4
Confirm the correct plate and mesh profile are active.Not completed
5
Return first-layer flow to the validated profile before compensating with Z offset.Not completed
6
Check that the nozzle is installed correctly and the hotend is mechanically secure.Not completed

Private workshop notes

No notes recorded.

Model: Single-layer five-zone test
Setup: Use the final plate, material, mesh and first-layer profile.
Pass: Lines join evenly in the centre and corners, with no scraping, gaps or lifting.
If unchanged: One or more zones remain loose, transparent, ridged or detached.

Matched next step

Use the free calibration path, save the settings that worked, and explore the Characters & Creatures collection that includes Bed Leveling Gremlin.