Repair workspace

Supports Hard to Remove

Free visitors can keep progress on this device. Members can move proven settings and notes into Profile Vault for account-level history.

Fast answer

Start here

Use the correct support gap/interface for the actual layer height and material, then improve orientation before increasing support density.

SupportsEasy14 min

Progress

Progress is stored only in this browser unless you deliberately save a member profile.

Step 1

Inspect orientation and move supports away from visible faces when possible.

Step 2

Confirm support top distance matches the slicer layer-height logic.

Step 3

Use a support interface, but reduce excessive density/layers.

Step 4

Tune temperature and cooling using an overhang test.

Step 5

Use tree/organic support for isolated features when suitable.

Step 6

Split the model if a clean joint is better than a damaged underside.

Step 7

Test a small representative section before a long print.

Private notes on this device

Save proven profile as a member Escalate to AI Doctor