PUBLIC SETTINGS SAMPLE
START WITH A RANGE. TUNE WITH EVIDENCE.
These values are conservative starting ranges. Always begin with the printer and material manufacturer profile, then use small calibration tests.
SLICE
TEST
TEST
Recommended starting range
PLA · Direct drive / unknown · balanced
Nozzle temperature200–215°C
Bed temperature55–65°C
Print speed45–70 mm/s — Start near the middle of the range.
Retraction0.8–1.4 mm @ 30–45 mm/s
Cooling80–100% after layer 3
ContextStrong starting material for most decorative prints. Nozzle selected: 0.4 mm.